To remove the windshield washer fluid reservoir, first disconnect the negative battery cable. Next, remove the wipers and wiper arms. Locate the three bolts that secure the reservoir to the firewall and remove them. Finally, pull the reservoir out of…
There are two main types of brakes used on bicycles: caliper and cantilever. Caliper brakes are the more common type, consisting of two brake pads that clamp down on the wheel when the lever is pulled. Cantilever brakes have one…
Yes, if there is air in the brake line it can cause the caliper to stick. When brakes are applied, fluid is forced from the reservoir into the caliper pistons. If there is a leak in the system, air can…
No, you cannot splice an ABS sensor wire. The ABS sensor is responsible for monitoring the speed of the wheels and relaying that information to the ABS system. If the ABS sensor wire is damaged, it will need to be…
Installing caliper brakes on a bicycle is a simple process that can be completed in just a few minutes. First, remove the wheel from the bicycle and then use a 5mm allen key to loosen the bolts that secure the…
If your brake caliper is sticking, you may need to release the pressure in the caliper. To do this, you will need a C-clamp and a piece of wood. Place the wood against the piston in the caliper and use…
There are a few ways to remove ball joint rivets, but the most common is with a drill. First, you will need to drill out the old rivets. Be sure to wear safety goggles and gloves when doing this. Next,…
The rear view mirror ball joint is located at the top of the windshield on the driver’s side. It is held in place by two screws. To remove it, first loosen the screws with a screwdriver. Then, pull the ball…
Your brake caliper piston may not be compressing for a variety of reasons. The most common reason is that the brake pads are worn out and need to be replaced. Other possible causes include: a build-up of rust or debris…
Coilover suspensions are a type of vehicle suspension that uses coilover springs. They are generally used in racing cars and performance vehicles. Lowering springs are a type of vehicle suspension that lowers the ride height of a vehicle. Lowered vehicles…
Bad ball joints can make a lot of noise. It may sound like a squeak or a grinding noise when you turn the steering wheel. The noise is caused by the wear and tear on the ball joint itself. If…
Yes, coilovers improve ride quality because they allow for adjustability and a more customized suspension. Coilovers also provide a firmer ride, which can improve handling on the road or track. Coilovers can improve the ride quality of your car by…
Coilovers are a type of suspension that can replace your car’s struts. They offer adjustable ride height and damping, so you can tune them to your liking. Coilovers also tend to be lighter than struts, which can improve your car’s…
To fix a cigarette burn in a car headliner, first remove the burned area with a pair of scissors. Then use a piece of sandpaper to lightly sand the area around the burn. Next, apply a thin layer of automotive…
There are a few ways to adjust camber on coilovers, but the most common is by adjusting the bottom mount. To do this, first loosen the bolts that hold the bottom mount in place. Next, rotate the bottom mount until…
Coilover shocks are a type of suspension that uses springs and shocks together in a single unit. The coilover shock is mounted to the chassis of the vehicle and the spring is mounted around the shock. This allows for easy…
There are a few ways to adjust coilovers stiffness, but the most common is to use a wrench or an Allen key. Most coilovers will have an adjustable knob that can be turned clockwise or counterclockwise to increase or decrease…
Coilovers are a type of suspension system that combine the coil spring and shock absorber into one unit. Adjusting the height on coilovers is a fairly simple process that can be done with a few basic tools. First, you will…
A sway bar link connects the sway bar to the suspension, and its main purpose is to keep the body of the vehicle level when cornering. If a sway bar link is worn out or broken, it can cause the…